WE GBB XM177 NPAS installed GBB

XM177, which has been used in a wide range of years since the Vietnam War, has been upgraded with RA-TECH NPAS installed !
The body will be a non-engraved model.
The attached magazine will be a short magazine, of course A1 grip!
The operation works smoothly with 134/152.
It is also ideal as a base for complete production.

about XM177

About 1 year from 1966 to 1967, the US Army purchased and adopted about 3000 M177E1 as a submachine rifle.
There are models in this series that are not engraved, and it is said that they used non-engraved ones in order not to know which country the soldier was.
Sequentially put into actual battle, it was pointed out that the 10 inch outer barrel length could not ignite glare bullet enough, and that the trajectory could not be confirmed in night battle, later changed the outer barrel length to 11.5 inch, M629 and M649 will be developed.
By extending the outer barrel, gunshots and flames are reduced, and a grenade launcher can be used.
The US Army adopted M629 as MACV-SOG, and the US Navy adopted XM177E2 for SEALS. Between April 1967 and September 1967, about 500 XM177E2 were put into actual operation.

Specifications

Full length: 755/840mm
Weight: 2,400g
Magazine capacity: 20rd+1

Accessories

Magazine x1
BB loader x1
Disassembly wrench x1
NPAS dedicated wrench x1

about NPAS

NPAS is a part to be installed in the bolt carrier that can change the flow rate to distribute the gas rising from the magazine to the initial speed side and recoil side.
In general, it is a type that swings to the recoil side, so that the recoil amount of blowback can be adjusted.
Please be assured that there is no extreme initial speed UP even if you swing to the initial speed side.

* Products are imported directly from Taiwan, so there may be uneven paint and small scratches during packaging / manufacturing.