USA, Australia, China, Malaysia, Singapore, Korea, Russia
The refund amount from us will be deducted 4% Paypal fee. If you remit the money without confirming this issue,
Airsoft Gun and Parts Product of in japan
ORGA AIRSOFT
Due to the law, we cannot accept ship to following countries.
USA, Australia, China, Malaysia, Singapore, Korea, Russia
The refund amount from us will be deducted 4% Paypal fee. If you remit the money without confirming this issue,
USA, Australia, China, Malaysia, Singapore, Korea, Russia
The refund amount from us will be deducted 4% Paypal fee. If you remit the money without confirming this issue,
QTY：0
Cost：$0
This is an M-LOK compatible handstop that is an elaborate reproduction of the RAILSCALES QTR Stop. Although the overall length is shorter than the M-LOK 1 slot, it is effectively mounted using one slot. In addition to fine-tuning the front/rear position within the slot, it can also be mounted across the slot.
In addition to its wide design, both ends are extended along the handguard to fill the gap, allowing it to be held at multiple angles regardless of the state of the support hand. The large surface also distributes the pressure against the support hand, preventing it from digging in.
This size is suitable for handguards with a wide M-LOK placement surface, such as the SIG MCX Virtus and Rattler U. It is also recommended for handguards with internal suppressors, such as the MAXIM MDX.
Overall length: 27mm
Overall width: 37mm
Overall height: 22mm (from M-LOK surface)
M-LOK compatible width: 23mm
Hand guard side angle: 45 degrees
Weight: 15g