Magnus Barrel for AEG - 455mm

This 6.23mm diameter ORGA MAGNUS barrel is the widest inner barrel in the world.

The ORGA's original HOP-Up shape, allows anyone to easily produce a “Flat HOP” equivalent to the ProShop. The flat HOP-Up can hold the BB pallet loaded in the chamber with its surface, providing a more stable backspin rotation than the normal HOP-Up or RHOP.
By doing so, it can give a stable shooting accuracy. It has gained support from AEGs and Polarster gun users.

# Explanation about the performance of widebore About WideBore

The difference between a normal inner barrel and a Magnus barrel is explained below.

Friction may occur if the inner barrel’s diameter is narrow. When the inner barrel is narrow, genuine barrels and tight barrels, anything less than a 6.08mm diameter, increases the number and time the airsoft pellets hit the tube wall leading to frictions.
On the other hand, if you use a long inner barrel for the AEG, the initial speed decreases when applying hop-up. This is related to the inner tube friction explained above.



The MAGNUS barel has a diameter of 6.23mm which can reduce the friction enabling the airsoft pellet to fire smoothly. This creates a higher shooting accuracy.




Cutting the upper part to reduce the distortion of the bullet feed
The Magnus barrel has been made lower on the left side of the HOP-Up rubber band. This allows the Hop-Up’s lower part and packing’s gap to be pulled, preventing the bullet feed’s rubber from pulling when Hop-Up is applied.
This can be beneficial since the shape of the bullet feed do not change making it airtight.



Packing attachment with horizontal/ vertical slit process
There are two slits on the left and right sides of the barrel. It can be attached to the barrel by rotating the chamber packing 90 degrees. A general packing has a protrusion on the inside. Although, for a airsoft pellet, it can achieve higher shooting accuracy with a flat hop-up packing.
Before, each player would turn the packing inside out, scraping the protrusion off to make a flat hop. Although this created problems since the processed hop would be rough or uneven from the other surface, leading to low performance.
In addition, forcibly turning it inside out caused the packing itself to grow, leading to leaks of air.



Just rotate the packing and attach!
As described above, a perfect surface HOP can be created by simply aligning the inner slits of the packing with the left and right slits without having to scrape the packing inside.
ANYONE/ WITHOUT ALTERCATION/ HIGHER QUALITY than ProShop